2026 Price Guide
How much does a fence cost in Santa Clarita?
Real installed figures by the linear foot, published here rather than held back until somebody is standing in your yard. Below is what a fence costs in Santa Clarita by material, and what pushes a quote up or down on these valley floor and foothill lots.
What each material costs
| Material | Installed per linear ft | 100 ft run | 150 ft run |
|---|---|---|---|
| Chain link | $18 - $40 | $1,800 - $4,000 | $2,700 - $6,000 |
| Wood privacy | $30 - $60 | $3,000 - $6,000 | $4,500 - $9,000 |
| Vinyl (PVC) | $40 - $70 | $4,000 - $7,000 | $6,000 - $10,500 |
| Wrought iron | $50 - $120 | $5,000 - $12,000 | $7,500 - $18,000 |
Worth knowing before the cheapest row settles it. UDC 17.57.070 does not permit chain link in a required front yard, and asks that it stay out of view from a public right of way. Price it for a rear boundary or a Canyon Country perimeter, not for the street side.
Each range includes posts set in concrete, the panels or pickets themselves, any gate and hardware falling inside the run, and the labor to install it. The written quote you receive is drawn to your own boundary, your material, and the fall of your lot.
Which end of that spread is yours? A level Newhall side yard and a Canyon Country run stepped down a cut-and-fill pad sit at opposite ends of the same column, and only a measured boundary settles it.
Gates, pool barriers, and the add-ons
| Add-on | Installed |
|---|---|
| Walk gate | $350 to $1,200 each |
| Manual driveway gate | $2,000 to $8,000 and up |
| Operator on an automatic gate | add $1,500 to $5,000 |
| Pool barrier, removable mesh | $15 to $30 / linear ft |
| Pool barrier, permanent metal | $40 to $90 / linear ft |
| Tear-out and haul-off of the old fence | $3 to $10 / linear ft |
Each of these is quoted as its own line rather than folded into the per foot rate, so a driveway gate for a master-planned tract or a five foot pool barrier is never hidden inside the fence figure. Tell us which ones your lot needs and they are priced out alongside the run.
What drives the price up or down in Santa Clarita
- Flat lot versus graded pad. Flat lots in Newhall set posts quickly. The cut-and-fill pads across Canyon Country and Saugus step down a slope, so posts need deeper footings and panels are racked or stepped to follow the grade, which adds labor and concrete.
- Expansive clay soil. The valley clay swells and shrinks with the seasons and works a shallow post loose, so footings here are dug deeper and wider than a sandy-soil job would need.
- Fire-zone material. On foothill lots inside the Very High Fire Hazard Severity Zone that Cal Fire expanded in 2025, non-combustible iron, steel, or block near the house costs more than the wood it replaces there.
- HOA-approved material. The master-planned tracts sometimes require a specific finished style or color along a visible boundary, which can steer you toward a pricier line and add review time.
- Gated-tract and canyon access. Coordinating entry to a gated community, or staging material up a narrow canyon road, can add a modest amount to the labor.
- Removing an old fence. Tear-out and haul-off carry a charge of their own at $3 to $10 a foot. It appears as its own line rather than buried inside the per-foot rate.
- Equestrian fencing. On the horse-zoned Sand Canyon and Canyon Country parcels, ranch rail, pipe corral, and no-climb mesh price differently from a standard privacy fence.
Wood versus vinyl in Santa Clarita
The gap at purchase is roughly $30 to $60 per linear foot for wood against $40 to $70 for vinyl, and cedar or redwood carries the warm, natural face most tract backyards were designed around. What wood asks in return is attention: a stain or seal every few years against the hot inland sun, and pickets that may cup or check as the years pass. Vinyl reverses that bargain. It costs more on installation day, then never takes paint, keeps its color through the heat, and rides out the dry seasons, which is why a long privacy run in Canyon Country or Saugus so often ends up vinyl. Close to the house on a fire-zone lot near the brush, neither material belongs, and iron or block takes over. Our wood versus vinyl guide sets the two side by side in full.
Want the figure for your own lot?
We measure the run on site in Santa Clarita, read the fall of the ground and the soil beneath it, and leave a fixed written quote behind. Nothing is charged for the visit, and no card is needed to book it.
Book a free estimateIf you are still weighing materials, the overview of fence building in Santa Clarita covers every option side by side.
Questions about price
How much does a fence cost per linear foot in Santa Clarita?
Installed work in Santa Clarita runs $18 to $40 per linear foot for chain link, $30 to $60 for wood, $40 to $70 for vinyl, and $50 to $120 for wrought iron. Chain link and short level runs sit at the bottom of that spread, while ornamental iron and footings dug for a graded hillside sit at the top.
How much does 150 feet of wood fence cost in Santa Clarita?
Installed, 150 linear feet of six foot wood privacy fence comes to $4,500 to $9,000, and that figure carries the posts, the panels, the hardware, and the labor. Tearing out an old fence, footings dug deeper for a graded pad or for the expansive clay, or a premium cap and trim will carry it toward the upper end.
Why does a Santa Clarita hillside lot cost more to fence?
The cut-and-fill pads across Canyon Country and Saugus step down a slope, so posts need deeper footings and panels have to be racked or stepped to follow the grade. That extra labor and concrete, plus footings sized for the expansive clay, add to the per foot figure compared with a flat lot in Newhall.
Do HOA rules and gated access affect the fence price?
They can. A master-planned tract reviews fence style, color, and height before work and sometimes requires a specific finished material, which affects the timeline and the material cost. On a gated-tract lot, coordinating access and staging can add a modest amount to the labor as well.